Installation Instruction

13
31-46542-4
Installation Instructions
TOOLS REQUIRED
• 5/32” Allen wrench
• Utility knife
• Stepladder
• Bucket
• Level
• Appliance hand truck
• Tubing cutter
• 7/16” open-end wrench
• 1-5/16” open-end wrench
• #2 Phillips screwdriver
• Drill and bit set
• 5/16” socket
• Safety glasses
• Pliers
• 3/8” ratchet
• Torx T-20, T-30 wrench
HARDWARE SUPPLIED
• Anti-tip bracket & screws
• Panel mounting brackets
• Door panel templates- Pub # 31-46543
• Water filter - Part # GSWF
• Drywall Anchors and screws
MATERIALS REQUIRED
• 1/4” copper water line tubing or SmartConnect™
Refrigerator Tubing kits
• Water shut-off valve
• Custom panels for fresh food door, freezer drawer and
Convertible drawer
• Velcro w/adhesive if using custom toekick.
FLOORING
For proper installation, this refrigerator must be placed
on a level surface of hard material that is at the same
height as the rest of the flooring. This surface should be
strong enough to support a fully loaded refrigerator, or
approximately 1,200 lbs.
NOTE: Protect the finish of the flooring. Cut a large sec-
tion of the cardboard carton and place under the refriger-
ator where you are working.
REFRIGERATOR/FREEZER LOCATION
Ŷ Do not install the refrigerator/freezer where the
temperature will go below 55°F (13°C). It will not run
often enough to maintain proper temperatures.
Ŷ Do not install the refrigerator/freezer where
temperatures will go above 100°F (37°C). It will not
perform properly.
Ŷ Do not install the refrigerator/freezer in a location
exposed to water (rain, etc.) or direct sunlight.
Ŷ Install it on a floor strong enough to support it fully
loaded.