Installation Instruction

19
31-46542-4
Installation Instructions
STEP 9 REVERSE DOOR SWING
(cont).
13. With another person holding the door in place, align
the holes in the door hinge bracket with the holes in
the hinge. Install the screws to the top hinge first.
14. Install screws on the bottom hinge next.
15. Using a Torx T-20
wrench, tighten the
tension on
the hinge springs by
turning the screws
from 0 to |.
STEP 11 ATTACH HINGE GUARD
WARNING
Door Hinge Pinch
Point Hazard
This appliance must be installed & operated with
the hinge guard in place !
1. Tape hinge guard cover to side of case. Align cover
with top and front edges of case.
2. Attach hinge guard by sliding flat part between case
and hinge guard cover.
3. Fasten guard to door front using 4 screws.
STEP 10 ADJUST DOOR SWING
(if needed)
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing to 115°,
you may limit the door swing to a 90°
Skip this step if door opening is satisfactory for your
installation situation.
Ŷ2SHQWKHIUHVKIRRGGRRUWRDFFHVVWKHWRSDQG
bottom hinges.
Ŷ/RRVHQWKHERWWRPKLQJHVFUHZVWKDWDWWDFKHGWRWKH
unit
Ŷ3XOOKLQJHIRUZDUGVOLJKWO\LQVHUWKLQJHSLQLQWRWKH
hole nearest the unit.
Ŷ<RXPD\QHHGWRXVHDVPDOOKDPPHUWRIXOO\VHDW
them in place.
Ŷ5HWLJKWHQKLQJHVFUHZV
ŶRepeat for top hinge.
Door
Screws
Use Torx
T-20 Wrench
Install 1 pin,
per hinge for 90°
door stop.
Hinge screws
Cover
Hinge guard