Installation Instruction
18
31-46542-4
Installation Instructions
STEP 9 REVERSE DOOR SWING (if needed)
Skip this step if door swing is satisfactory.
WARNING
Follow all steps when reversing
the door swing. Failure to follow these instructions,
leaving off parts, or overtightening screws, can
lead to the door falling off and result in injury and
property damage.
1. Open the fresh food door.
WARNING
Door Hinge Pinch
Point Hazard
This next step is important for safe handling of an
unloaded hinge. Do not skip step 2.
2. Release the hinge springs by using a Torx T-20
wrench to loosen the Torx screw from | to 0 on both
hinges. Close the door.
3. Using a 5/32” Allen wrench, remove the 2 screws per
hinge that secure the door to the refrigerator. Have
someone hold the door while removing these screws
to keep the door from falling.
4. Open the hinges. Using a 5/32” Allen wrench, remove
the 2 screws per hinge that secure the hinge to the
refrigerator cabinet.
5. Remove the trim and hinge pocket from the top of the
refrigerator and install on the opposite sides.
6. Remove the trim and hinge pocket from the bottom
of the fresh food compartment. Remove the control
panel and gently place in the FZ drawer.
7. Reinstall the control panel.
8. The hinges will be reinstalled in opposite corners. The
hinge from the top will be turned over and installed at
the bottom of the fresh food compartment. The hinge
from the bottom will be turned over and installed at
the top of the fresh food compartment.
9. Install the screws on the fresh food compartment
cabinet in all 4 places. Screw them in about halfway.
10. To install the top hinge, turn the hinge in the proper
direction—the section of the bracket that will be
attached to the door should be at the bottom of the
hinge. Slide the hinge over the screws and seat the
tabs into the hinge pocket. Tighten the screws.
11. To install the bottom hinge, turn the hinge in the
proper direction—the section of the bracket that will
attach to the door should be at the top of the hinge.
Slide the hinge over the screws and seat the tabs
into the hinge pocket. Tighten the screws. Close the
hinge.
12. Remove the hinge brackets from the door and rein-
stall them on the opposite end, top and bottom.
Screws
Screws
Top Hinge Bottom Hinge
Slots for
Tabs
Screws
Screws
Control Panel