User`s manual

GLOBAL SETTINGS

The available selections for all the parameters are:

• INT - O

nly internal control, no external MIDI data will be sent.

• OUT - No internal control, only external MIDI data will be sent.

• INT+OUT - Internal control, and MIDI data will be sent.

• Parameter locks of the internal tracks are not transmitted over MIDI, because the

data transfer rate of the MIDI standard is too low for delivering large number of

control data in time.

• Note that if internal control is shut off the Monomachine might appear non-func-

ional if MIDI data is not echoed back from an external sequencer.

CONTROL OUT2

Here parameters dealing with how the Monomachine handles outgoing MIDI sequencer

control messages are found.

1. Select the CONTROL in the GLOBAL menu. Then select CONTROL OUT2 using the

[ARROW] keys and press [ENTER/YES].

TRANSPORT (transport) controls whether MIDI Start, Stop and Song Pointer Position are

sent.

MIDI CLOCK (MIDI clock) controls whether the Monomachine transmits MIDI clock.

PRG CHANGE (program change) controls whether MIDI PRG CHANGE is sent for each

pattern change.

CONTROL IN

In this menu it is defined how the Monomachine should react to incoming MIDI.

1. Select the CONTROL in the GLOBAL menu. Then select CO

NTROL IN using the

[ARROW] keys and press [ENTER/YES].

TEMPO SYNC (tempo sync) defines how the Monomachine should react to incoming MIDI

clock. When this parameter is set to EXTERNAL, the Monomachine tempo will be slaved to

incoming MIDI time clock. The precision of the timing is limited to the precision of the unit

transmitting the MIDI clock signal. When locked to external clock the BPM indicator on the