User`s manual

THE PATTERN SEQUENCER
49
3. The pattern will start on the first step of the seque
ncer. From here the active position will
automatically advance one step forward when a note or chord is programmed.
4. You can use the [LEFT] and [RIGHT] keys to move the editing focus of the pattern.
Press the [EXIT/NO] key to program a NOTE OFF, press [ENTER/YES] to clear a note.
• Use the step recording method as an experimental way of creating patterns. Inter-
esting results can be had!
NOTE COPY
It is possible to copy a note trig, complete with all parameter lock settings, and paste it to a
new location in the track.
1. Make sure you are in GRID RECORDING mode, indicated b
y the <RECORD> LED giv-
ing off a steady light.
2. Press and hold the note trig you want to copy and press the [RECORD] key. A message
“COPY NOTE” will appear.
3. Hold the [TRIG] key correspondning to the location you want to paste the note to and
press the [STOP] key to complete the paste operation. A message “PASTE NOTE” will
be shown.
CLEAR NOTE PARAMETER LOCKS
Instead of removing the parameter locks from a note you can also use the clear note locks
command.
1. Make sure you are in GRID RECORDING mode. The <RECORD>
LED should be lit.
2. Hold and press the [TRIG] key you whose content you want to clear. Then press [PLAY]
to clear the note. The message “CLEAR NOTE LOCKS” will appear.
The clear note lock operation can be undone by performing the clear note operation one
more time. The message “UNDO NOTE LOCKS” will be shown in the display.