User`s manual

Appendix A: MACHINE REFERENCE A-13
DYNAMIX TUTORIAL
This is just a general overview of one way
yo
u can approach the Dynamix processor.
No exact parameter values can be given as
they depend on the signal processed.
1. Turn up RAT. Setting the compression
ratio to zero (1:1) means that the signal
will pass straight through. Setting RAT to
its full value 127 (1:255) makes it a so
called limiter.
2. Turn THRS
down. The peaks of the input
signal should now be reduced.
3. Increase the RMS parameter if the incom-
ing waveform is low in overall volume but
have high signal peaks.
4. Adjust ATK and REL to match the input
signal. Too slow attack will cause over-
shoots (pumping) in the out signal.
5. Increase GAIN to compensate for loss of
volume.
RING MODULATOR
The ring modulator of the Monomachine
allows you to ringmodulate an incoming sig-
nal with an internal carrier oscillator.
WAVE (wave) selects the waveform of the
carrier oscillator. When WAVE is set to zero
the oscillator outputs a sine wave, when set
to 127 it outputs a triangle wave.
EXT (external signal) sets the amount of the
incoming signal that should be ringmodu-
lated with the waveform selected by the
WAVE parameter.
MIX (signal mix) adjusts the output between
the original “dry” signal and the “wet” signal.
INP (input signal amplification) adjusts the
signal input.