User`s manual

GLOBAL SETTINGS

6. To perform the send, press [E

NTER/YES]. You will see a sysex message counter on the

bottom of the screen indicating how many sysex messages have been sent of the total

amount of messages.

• SYSEX send mode “ALL” may take several minutes to complete, because of the

large amount of data transmitted.

• Don’t forget to save the data on the device you recorded it to. At any time during

the transfer you can also interrupt the transfer by pressing [EXIT/NO].

• To ensure that your data was received and stored correctly, use the SYSEX VER-

IFY function found in the SYSEX RECV menu.

• You can always cancel the SYSEX SEND operation by pressing the [EXIT/NO] but-

ton.

• Use the TM-1 MIDI interface available from Elektron for up to 10x the normal MIDI

transfer speed.

SYSEX RECEIVE

The SYSEX receive function makes it possible to restore previously transmitted data back

into the Monomachine.

1. Select FILE in the GLOBAL menu. Then select SYSEX RECV

using the [ARROW] keys

and press [ENTER/YES].

Use the [RIGHT] and [LEFT] keys to move between the tabs. Use the [UP] and [DOWN]

keys to alter the parameters. The LEVEL knob can also be used for setting the ranges.

MODE (mode of receival) controls how the Monomachine receives incoming sysex data.

• ORIG - The kits, patterns, songs and global slot data received will be placed on the orig-

inal positions they were located at when they were transmitted. Using this method it is

not possible to select any start positions in the WRITE POS FROM window.

• SPEC - You may specify the positions where you want the kits, patterns, songs and glo-

bal slots to be stored. Since the Monomachine does not know in advance what kind of,

and how much data it will receive, all you can specify is that the data will be placed start-