User`s manual

GLOBAL SETTINGS
92 Monomachine SFX-6/60 USER’S MANUAL
Transport controls if MIDI Start, Stop and Song Pointer Position will be sent.
MIDI clock controls if the Monomachine should transmit MIDI clock.
PRG CHANGE controls if MIDI PRG_CHANGE will be transmitted for each
pattern change.
CONTROL IN
The CONTROL IN window is printed below:
The tempo can be generated either internally or taken from an external MIDI
clock. The Monomachine gives best timing performance when set to internal
synchronisation. It transmits a very high precision MIDI clock on the MIDI
OUT port so that you can synchronise other devices to the Monomachine.
When the Tempo Sync parameter is set to EXTERNAL, the Monomachine
tempo is slaved to incoming MIDI time clocks. The timing is locked to the
external source, and the precision is limited to the precision of the unit trans-
mitting the MIDI clocks. When locked to external clock the BPM indicator on
the front screen tells “EXT”. If no timing clocks are received for a few sec-
onds the Monomachine falls back to internal source until MIDI clock is rec-
ognised.
Transport controls if the Monomachine should react to MIDI Start, Stop and
Song Pointer Position.
When the Transport parameter is set to ACCEPT, MIDI Start, Stop and Song
Pointer Position messages are recognized for synchronised song opera-
tions. In pattern mode midi song pointer position is recognised for starting
the pattern from the correct note.
When the Transport parameter is set to IGNORE, MIDI start, stop and Song
Pointer Positions are ignored. This is useful when you want the Monoma-
chine to be connected in your setup with the tempo synchronised, but do not
want the pattern to start each time you press play on your sequencer.
Instead you might want to use the Multi Trig or Multi Map functions. Or you
might want to use the Monomachine as a sound module, but still have the
tempo synchronised for the LFO’s and the delays.
PRG CHANGE controls if PRG_CHANGE received should change pattern
of the Monomachine or not.
• When the Monomachine is locked to external MIDI clock messages,
and MIDI clocks are no longer detected it will fall back to internal
sync. However, it will not change the sync source in the Global set-