User`s manual

GLOBAL SETTINGS
Monomachine SFX-6/60 USER’S MANUAL 91
• NRPN data is accepted to control the individual internal tracks
• PROGRAM_CHANGE can be used for changing pattern
The NRPN interface doubles with the normal CTRL_CHANGE interface of
the Individual Track Channels, and provide the same functionality. It is only
accepted, never transmitted. See Appendix: B for full MIDI specifications of
the NRPN interface.
The PROGRAM_CHANGE can be disabled for MIDI input and output. See
section “CONTROL OUT2” on page 91 for more information.
MIDI CONTROL DATA
The Global menus CONTROL OUT1, CONTROL OUT2 and CONTROL IN
contain the parameters that control how the Monomachine sends and
accepts MIDI control data. Navigate between the parameters using the [UP]
and [DOWN] keys. Change the parameter values using [LEFT] and
[RIGHT].
CONTROL OUT1
The CONTROL OUT1 window is printed below:
The parameter in this window control where data should be sent from the
internal Sequencer, the Arpeggiator and the Keyboard (only functional on
the SFX-6). Joystick control is included in the Keyboard parameter. The
available selections are:
• INT - Only internal control, no external MIDI data will be sent.
• OUT - No internal control, only external MIDI data will be sent.
• INT+OUT - Internal control, and MIDI data will be sent.
Note that if internal control is shut off the Monomachine might appear non-
functional if MIDI data is not echoed back from an external sequencer. Also
note that Parameter Locks will not be heard when echoed externally as they
are not transmitted over MIDI.
CONTROL OUT2
The CONTROL OUT2 window is printed below: