User`s manual

MONOMACHINE ROUTING
Monomachine SFX-6/60 USER’S MANUAL 85
In the example above the two first tracks are sent on the AB bus, and
effected by the FX machine on track 3. Track 4 and 5 are sent to the CD mix
bus. Track 6 is an FX machine with input taken from the CD Mix bus, which
now contain the mixed signal of track 4 and 5. The output of the FX machine
on track 6 is set to bus AB with differs from the input CD. Therefore the
effected track 4 and 5 is effected and sent to mix bus AB, where they are
mixed with the Track 1 and 2 effected by track 3.
ROUTING MODE AB=MIX
By default the mix buses are sent to the Audio Outputs with the same
names. If you are using only the main AB stereo outputs, or the headphones
which carry the same signal, you will not hear what is sent to the CD and EF
outputs. By setting the Global Routing mode (see section “GLOBAL ROUT-
ING” on page 88) to “3xSTEREO + AB=MIX” the CD and EF buses will be
mixed also onto the stereo main AB/headphone outputs.
ROUTING MODE 6xMONO
By setting the Global Routing mode (see section “GLOBAL ROUTING” on
page 88) to “6xMONO”, the AB, CD and EF mix buses will not be sent to the
audio outputs. Instead, each of the stereo outputs of the six Monomachine
tracks are mixed to mono, and feed to an individual output. The mix buses
can still be used, but the final output of them will not be sent to the AB, CD
and EF outputs.
Using this mode makes it possible to get the output of each of the Monoma-
chine tracks sent to an individual output, but the stereo effects and panning
are lost.