User`s manual

THE MIDI SEQUENCER
70 Monomachine SFX-6/60 USER’S MANUAL
THE MAIN MIDI SEQUENCER INTERFACE
The main MIDI sequencer interface screen is printed below:
The parameters of the main MIDI interface is listed below:
• LEN = NOTE LENGTH
• VEL = VELOCITY
• PB = PITCH BEND
• PCHG = PROGRAM CHANGE
• CC 1-4 = CONTROL CHANGE 1-4
The Note Length parameter set the maximum time the note will be played
until a NOTE_OFF is sent. Notes can also be interrupted with NOTE_OFF
trigs (set by pressing a [TRIG] key while holding [FUNCTION]). If you prefer
to stop notes with only NOTE_OFF trigs, set Note Length to its maximum
value to make it infinite of length. Use Parameter Locks to set different note
lengths for different notes.
The Velocity parameter control the MIDI velocity sent for each note. Use
Parameter Locks to set different velocity for different notes.
The Pitch Bend parameter control the MIDI pitch bend setting.
The Program Change parameter can be used for outputting MIDI program
change commands, to change the patch of the external MIDI device. The
program change parameter only transmits data when used for Parameter
Locks. It is not possible to slide the Program Change parameter.
The CC 1-4 parameters sets the control change parameter values. Which
parameters that are used is set in the Global “MIDI SEQUENCER SET-
TINGS” menu page (see page 97 for more information).
The settings of the main MIDI sequencer interface is stored as part of the kit.
If you make changes to the parameters you need to save the kit in order to
keep them.