User`s manual

ADDITIONAL SEQUENCER FEATURES

Monomachine SFX-6/60 USER’S MANUAL 65

SLIDE

The default behaviour for parameter locks is that the value changes exactly

when the step is played. By using the Slide Tracks, the parameter value

changes made by parameter locks can be slidden smoothly between the

start and end lock value. The Slide Tracks are saved as part of the pattern.

The Slide window is called by pressing [SLIDE] while holding [FUNCTION].

Select which track you want to edit the Slide Track for using the [TRACK]

keys.

The slide window is printed below:

The <TRIG> LED’s indicate which steps will be slidden, and the [TRIG] keys

are used to switch their state. If your pattern is longer than 16 steps, use the

[SCALE] key to cycle between the pages.

For a parameter to be slidden it need to be locked at two steps. If the Slide

Track is set for the same step as there is a parameter lock, the parameter

will slide to the next value it is locked to on a later step. The speed of the

slide is relative to the current tempo. The slide is always completed exactly

when the next step with the same parameter locked is reached.

• Only parameters locked on the steps selected in the Slide Track, and

on a later step, will slide. Parameters that are unlocked, or only

locked at one step will not slide.

• If there are trigs in between the two locked parameter where the

parameter is not

locked, the parameter will slide between the two

locked positions and is not interrupted by the unlocked trig in the

middle.

The figure ”Slide illustration” below show an example on how the Slide

Track influence a parameter locked. The first Slide Trig makes the parame-

ter slide to the next locked parameter value. Even though there is a trig in

the middle it does not interrupt the slide. When the destination is reached

the locked value is held and not slidden, as there is no Slide Trig for that

position. For the last three Slide Trigs, it is only the middle one that is caus-

ing any slide, as the other Slide Trigs do not have any parameter locked at

the same step.