User`s manual

ADDITIONAL KIT SETTINGS
Monomachine SFX-6/60 USER’S MANUAL 37
ADDITIONAL KIT SETTINGS
This chapter deals with all kit settings not covered in the previous chapters.
ASSIGN
The Kit Assign allows the Joystick, Key velocity and Key position tracking to
be assigned to up to two Data Entry parameter of choice. This can allow for
a lot of dynamic depth of the sound with little effort.
You find the Assign window in the Kit menu. Press the [KIT] key and navi-
gate to the Assign icon using the [CURSOR] keys, then press [ENTER/
YES] to enter the Kit menu.
In the Assign window you will find a minimum of four and a maximum of six
tabs. Navigate between the tabs using the [LEFT] and [RIGHT] keys. Use
the DATA ENTRY encoders to change settings of the parameters on the
tabs.
The Assign settings are applied per track. Select which track you want to
edit the assign for with the [TRACK] keys.
All tabs have two rows with three parameters in each in common. The Page
(“PAGE”) and Destination (“Destination”) parameters together select the
destinations for the assigns. Each of the destinations have an Add/Depth
(“ADD”) setting, which control how much of the control value that will be
applied to the destination parameter.
• The Page parameter selects between the seven Data Entry pages,
plus the special Pitch destination.
• The Destination parameter allows to select one of the eight parame-
ters in the page.
• The Add/Depth parameter controls how much of the parameter cho-
sen will affect the destination as maximum. The Add/Depth can be
set to positive and negative amounts.
• Setting Depth to +64 or -63 allows for modulating a parameter to any
extreme value. For example, if the target parameter is set to 64 a
Depth setting of +32 is sufficient for modulating the target value to
its maximum (127). If the target value is set to zero, a Depth setting
of +64 is needed for the target to be able to reach its maximum
value.