User`s manual

LOW FREQUENCY OSCILLATORS (LFO’s)
34 Monomachine SFX-6/60 USER’S MANUAL
TRIG MODE
The Trig mode switch (“TRIG”) is an important parameter for getting the
most out of the LFO's. The trig modes are described in the list below, and
their function is visualised in combination with the waveforms in Figure 3 on
page 32.
• FREE = The LFO is running continuously, never restarting or stop-
ping.
• TRIG = The waveform is restarted for each LFO-trig, and then runs
continuously.
• HOLD = The waveform is running free in the background, but the
output LFO level is latched for each LFO-trig and held still until the
next LFO-trig.
• ONE = The waveform is restarted for each LFO-trig, then runs for
one cycle and finally stops and holds the last LFO level.
• HALF = The waveform is restarted for each LFO-trig, then runs for
one half cycle and finally stops and holds the last LFO level.
• In the Monomachine you can sequence LFO-trig separately from
other trigs. Check page 48 for more information on the Trig Tracks.
FIGURE 3. Monomachine LFO waveform and Trig modes