User`s manual

LOW FREQUENCY OSCILLATORS (LFO’s)
Monomachine SFX-6/60 USER’S MANUAL 33
LOW FREQUENCY OSCILLATORS (LFO’s)
Each of the 6 tracks in the Monomachine offers 3 interlaced low frequency
oscillators (LFO), which can be used to modulate any track parameter. A
typical application of an LFO is to let it sweep a filter cut-off frequency. The
18 interlaced LFO’s offer 11 waveforms and 5 trig modes. The LFO’s are
tied to their specific tracks, and are shared between the internal sequencer
and the midi sequencer. The speeds of the LFO’s are synchronized to the
global tempo.
First select a track using the [TRACK] keys that you want to alter the LFO’s
for. Then use the [DATA PAGE] keys to locate one of the three LFO pages.
All the three LFO’s of the track are identical. The <DATA ENTRY> LED’s
indicate which Data Entry page is currently selected, and the DATA ENTRY
encoders control the parameters of the Data Entry page selected.
LFO CONTROLS
The three LFO’s of each track are identical. They can control any parameter
of the track for the internal or the MIDI sequencer, as well as the other
LFO’s. The LFO control interface is printed below:
1. Page and Destination
2. Trig Mode
3. Waveform
4. Multiplier and Speed
5. Interlace
6. Depth
PAGE AND DESTINATION
The Page (“PAGE”) and Destination (“DEST”) parameters control which
parameter you wish the LFO to modulate. All seven Data Entry pages, plus
the MIDI Sequencer and the special Pitch page are accessible by the LFO.
On the Pitch page you will find 8 Destinations offering various ranges to
allow for both subtle vibrato and full range frequency sweeps.
You can create complex modulations by letting an LFO control a
parameter of another one.