User`s manual
TRACK EFFECTS
30 Monomachine SFX-6/60 USER’S MANUAL
EFFECTS PAGE
In the Effects page you find the controls for the 1-band EQ, Sample Rate
Reduction, and the tempo-synchronised tape-style Delay.
The parameters of the effects page are listed below:
• EQF = EQ FREQUENCY
• EQG = EQ GAIN
• SRR = SAMPLE RATE REDUCTION
• DTIM = DELAY TIME
• DSND = DELAY SEND AMOUNT
• DFB = DELAY FEEDBACK
• DBAS = DELAY FILTER BASE
• DWID = DELAY FILTER WIDTH
EQ
Using the 1-band parametric EQ, you can boost or reduce a certain fre-
quency band.
The frequency where the EQ will boost or reduce is controlled by the EQF
parameter.
The EQG parameter controls how much the EQ will boost (gain) or reduce
the signal around the EQF frequency. Positive values boost the signal and
negative reduce up to a maximum of 36dB.
• If you notice that the signal overload when you boost the signal you
might need to increase your headroom by decreasing the DIST
parameter on the Amplification page. Please see section “DISTOR-
TION” on page 26 for more information.
SAMPLE RATE REDUCTION
The sample rate reduction effect resample the signal at a lower sample rate,
introducing alias effects which gives a digital “lo-fi” effect. The SRR parame-
ter controls the amount of sample rate reduction down to a lowest of 2.8kHz.
• The Sample Rate Reduction often gives best effect on signals with
some, but not too much, high frequency contents. Sound with too
much high frequency information might introduce too much alias,
resulting in a very disharmonic signal.