User`s manual

QUICK START
Monomachine SFX-6/60 USER’S MANUAL 13
RECORDING A PATTERN USING GRID COMPOSING
1. You can input notes into a pattern of the sequencer, both while it is play
and stop mode. First select the pattern you wish to edit. You might want to
select an empty pattern, as all changes are made “live” to the pattern. As
factory default, patterns E01-H16 are clear.
2. If you wish you can change the kit assigned to the pattern by selecting
pressing the [KIT] key, then select LOAD in the menu, and select the kit
you prefer from the list presented.
3. Press the [RECORD] key to enter grid recording mode. The <RECORD>
LED should be firmly lit.
4. Select the active track using the [TRACK] keys.
5. Press a [TRIG] key to add a Note On trig. A Note On trig is indicated by a
red <TRIG> LED. To set the pitch of the note, press the corresponding
key on the keyboard while the [TRIG] button is held. You can also use the
[CURSOR] keys to edit the programmed pitch. Pressing the same [TRIG]
key once more removes the Note On.
6. To enter a Note Off trig, press a [TRIG] key while holding the [FUNC-
TION] key. To remove a Note Off the same [TRIG] key must be pressed
twice. A Note Off is indicated by a yellow <TRIG> LED.
7. To change the pitch of a note, press and hold the [TRIG] key. You will see
a mini keyboard pop up in the lower left corner of the screen. Either press
the new note on the keyboard or use the [CURSOR] keys to select the
new note. When done release the [TRIG] key.
8. To edit other tracks, change the active track using the [TRACK] keys.
PATTERN LIVE RECORDING
1. The live recording mode allows you to record notes in real-time while the
pattern is playing. To start this mode, press and hold [RECORD] and then
[PLAY].
2. You can now play notes on the track you want to record. All played notes
will be quantised and recorded to the closest trig step.
3. If a note is played on a position where there already was a note pro-
grammed the new note will replace the note on that step.
4. To erase notes on live recording mode hold [EXIT/NO] while the notes
you want to remove are heard.
5. The pattern will loop and be ready for further recording until you press the
[STOP] key.