User`s manual

QUICK START

12 Monomachine SFX-6/60 USER’S MANUAL

To stop the playback of the pattern, press the [STOP] key.

PLAYING IN MULTI TRIG MODE

1. Select a pattern, ranging from A01-D16. All the Monomachine presets are

located in this range. Make sure the sequencer is stopped.

2. Enter Multi Trig Mode. On SFX-6 press the [MULTI TRIG] key and check

that the <MULTI TRIG> LED is lit with a steady light. For SFX-60 select

the Multi Trig channel on your midi keyboard.

3. Play some notes!

4. Depending on the trig mode selected in the kit a number of things could

happen. Please refer to section “MULTI TRIG” on page 40 for a the full

story.

• All presets of the Monomachine are designed as patterns with asso-

ciated kits that can be played in Multi Trig mode. To explore the pre-

sets, select the patterns between A01 and D16, and play them in

Multi Trig mode as described in this section.

EXPLORING A PATTERN

1. Select a pattern as described above.

2. Make sure the sequencer is stopped and that Multi Trig Mode is switched

off on the SFX-6 (<MULTI TRIG> LED not lit) and that the sequencer is

not in grid composing mode (<REC> LED not lit). Use the Auto Channel if

using an external MIDI control keyboard.

3. Select one of the six tracks as the active track by pressing a [TRACK]

key.

4. For each track the machine loaded is displayed in the lower left corner of

the display.

5. Play some notes on each of the tracks, either using the keyboard or the

[TRIG] keys. Note that it’s possible that not all tracks will sound, the track

can be an FX that needs input from another track or silenced due to the

output assigning, machine selection or Track Effect settings.

6. Use the [DATA PAGE] keys to navigate between the Data Pages. The

<DATA PAGE> LED’s will indicate the current selection. Select the Syn-

thesis page.

7. Now, turn any of the DATA ENTRY knobs to tweak the machine synthesis

parameters on the selected track. You can change any parameters with-

out fear of loosing presets or other kits stored, as the changes will not be

saved if you do not choose to perform the Kit Save action. The parame-

ters presented on the Synthesis page are specific to the machine loaded.

See Appendix: A for information about the parameters and functions of

the machines.

8. Continue to the Track Effect pages, named Amplification, Filter and

Effects pages and explore the wide range of sound shaping tools availa-

ble. The parameters on these pages are always placed in the same order

to assist the sound creation process. You can find information about the

Track Effects on page 25.