User`s manual

A-14 Appendix A: MACHINE REFERENCE
DYNAMIX TUTORIAL
This is just a general overview of one way
you can approach the Dynamix processor.
No exact parameter values can be given as
they depend on the signal processed.
1. Turn up Ratio. Setting Ratio to zero (1:1)
means that the signal will pass straight
through. Setting Ratio to its full value 127
(1:255) makes it a so called limiter.
2. Turn Threshold down. The peaks of the
input signal should now be reduced.
3. Increase the RMS parameter if the incom-
ing waveform is low in overall volume but
have high signal peaks.
4. Adjust Attack and Release to match the
input signal. Too slow attack will cause
overshoots (pumping) in the out signal.
5. Increase Gain to compensate for loss of
volume.