User`s manual

GLOBAL SETTINGS
Monomachine SFX-6/60 USER’S MANUAL 95
• ALL - All Monomachine data (Patterns, Kits and Global data). This
can be used for making a full backup of all the Monomachine mem-
ory data.
• KIT - The selected Kits.
• PAT+KIT - The selected Patterns and their associated Kits
• SONG+PAT+KITS - The selected songs, the Patterns used in them,
and their associated Kits.
For all but the “ALL” selections a range can be set using the [UP] and
[DOWN] keys or the LEVEL encoder. For “PAT+KIT” you can set the range
limits also with the [BANK]+[TRIG] keys.
Before transmitting the data, make sure the device connected to the MIDI
OUT of the Monomachine is ready and waiting for data. Then perform the
data transfer by pressing [ENTER/YES]. A SYSEX data counter will be dis-
played on the bottom of the window, counting until it reaches the number to
the right, which indicates the total number of SYSEX messages to be sent.
After the counter has stopped you can exit the window by pressing [EXIT/
NO]. Don’t forget to save the data on the device you recorded it to. At any
time during the transfer you can also interrupt the transfer by pressing
[EXIT/NO].
• SYSEX Send mode “ALL” may take several minutes to complete,
because of the large amount of data transmitted.
• To ensure that your data was received and stored correctly, use the
SYSEX verify function in SYSEX receive as described in the section
below!
SYSEX RECEIVE
The SYSEX receive function makes it possible to restore previously trans-
mitted data back into the Monomachine. There are two methods for receiv-
ing incoming SYSEX data named Original Place and Specific Place. There
is also an additional method named Verify, which do not alter any informa-
tion in the Monomachine, only verifies that the messages received are cor-
rect.
You will find the SYSEX Receive menu in GLOBAL>FILE>SYSEX SEND.
Use the [RIGHT] and [LEFT] keys to move between the Selection and
Range tabs, and inside the Range tab if sub selections are available for the