User`s guide

32
Process Menu
The process pop-up menu, located under a module’s “Process”
label, lets you select which DSP process is performed by this
module.
The selected DSP process modifies or analyzes the input signal and
sends the result to the modulation block and to any selected
outputs.
To select a DSP process:
1. Hold the mouse button down over the process pop-up.
2. Select the desired DSP process and release the mouse button. The
name of the selected process will appear on the pop-up menu.
3. Specify the desired DSP parameters by entering values into the
associated text entry fields.
No Process
If you select No Process, the source signal (after any incoming Mix,
Amplitude and Ring modulations) passes through the processing
block unchanged.
Envelope Follower
Use the Envelope Follower to extract the amplitude envelope of a
signal, as shown in the following illustration: