User`s guide

10. Next we want to add some vibrato to our filter frequency

modulation. Click the On/Off checkbox to enable Module 5. (All

eight modules are interchangeable; we choose Module 5 for

convenience, since it is located below Module 1.)

For the source, select “Sine.” Set the frequency to 6 Hz and the

initial phase to 0°. Leave the process set to “No Process.” Set the

first modulation pop-up menu to “Filter Freq Mod,” with Module 2

for the Destination and 10% for the Modulation Amplitude.

Now both the Pitch Tracker and the 6 Hz sine wave are

modulating the bandpass frequency, resulting in a musical saw

effect. Set the Mod Amp to 5% if you want to reduce the vibrato

depth. Again, we don’t want to hear the output of this module

directly, so we leave the Left and Right Output checkboxes off.

11. Now mix in a little of the unprocessed (“dry”) audio. Turn on

Module 6 and select the original sound by setting the Source

pop-up menu to “Stereo In.” Choose the Delay process with a

delay time of around 60 ms., to offset the delay produced by the