User`s guide

7. Click the On/Off checkbox for Module 1, turning it on. This

module will perform the pitch analysis and the filter frequency

modulation.

Since we want to analyze the input signal, we select “Stereo In” as

our source.

8. For the process in Module 1, we have selected PitchTrack. The

Low and High Frequency fields have already been set to match

the pitch range of the source material.

The Pitch Tracker will run faster and track more accurately if the

Low and High Frequency fields closely match the lowest and

highest pitches in the source material.

9. Select “Filter Freq Mod” for the first (top) modulation in Module 1.

Set the Dest pop-up menu to 2, so the Pitch Track information

will control the bandpass filter frequency in Module 2. You can

think of the Dest menu as an invisible patch cord from the

modulator to the destination:

Set the Mod Amp field to 200% to raise the frequency modulation

an octave.

Then set it to 400% to raise it another octave. Note that the result

sounds like someone whistling.

We don’t want to hear the output of the Pitch Tracker directly, so

we leave Module 1’s Left and Right outputs off.