Product data
8. Assign any additional sensors.
When you have nished setting up the sensor, you will see a conrmation screen. At
this point you can assign additional sensors to your network or begin using the system
by clicking “Done”.
2. Using the MonnitLink CGW2 Cellular Gateway
1. Understanding the Ethernet Gateway Lights
GSM/GPRS registraon is OK (CGW is registered successfully in the
1 2
3
GSM/GPRS network registraon is in progress
Last communicaon transacon with Monnit’s server was unsuccessful
Last CGW communicaon with Monnit’s server is OK
CGW - Sensors communicaon problem
CGW communicaon with the sensors is OK
Blinking: CGW communicaon with Monnit’s server is in progress
Blinking: Sensors communicaon with CGW is in progress
GSM network)
Note 1: The CGW resets itself after receiving new conguration from the server (ex. new HB),
LED1 starts with RED and the reset cycle continues till all 3 LEDS are GREEN
Note 2: After successful SW upgrade , LED 2 and 3 ash RED then reset cycle starts.
2. Cellular Gateway Controls
Using the Control Button:
1) Pressing the power button will turn the device on or off. Powering on the device
will trigger the gateway to immediately send all stored sensor messages to the online
system and download any pending system messages to deliver to the sensors. (The
default heartbeat for the cellular gateway is 5 minutes.)
2) Press and hold to Factory Reset Button to reset the gateway to factory settings.
This resets the gateway heartbeat to 5 minutes. You will need to login to the online
system after resetting the gateway to recongure the gateway to your desired settings.
Note: If your gateway powers up and the lights do not turn green, you may have a connectivity
issue. Wait a few minutes to see if the lights will turn green. If they do not, power off the device by
pressing the power button, then turn the device back on. If it still does not connect, try resetting
the device to the factory settings. If this still does not x the issue, call Monit customer support.by
disconnecting then reconnecting power. If it still does not connect, try resetting the device to the
factory settings. If this still does not x the issue, call Monit customer support.
PAGE 4
Control Button
Power Switch