User`s guide
PAGE 3
7. Conrmation Screen.
When you have nished adding the sensor, you will see a conrmation screen. At this
point you can assign notications to the sensor (see Using The iMonnit™ Online Wire-
less Sensor System) , assign additional sensors to your account or click “Done” to go
to your sensors overview page.
2. Using the MonnitLink
™
Ethernet Gateway
1. Understanding the Ethernet Gateway Lights
Front of Ethernet Gateway
1 2 3
Light 1 - Indicates the Ethernet cable is plugged in. A green light indicates ready and
working, a red light indicates there is a problem.
Light 2 - Indicates the Ethernet has internet connectivity and can reach the online
monitoring system. A green light indicates ready and working, a red light indicates
there is a problem. A ashing green light indicates network trafc to the internet.
Light 3 - Indicates sensor network activity. A green light indicates ready and working,
a red light indicates there is a problem. A ashing green light indicates radio trafc
from the sensors.
For help troubleshooting Ethernet gateway lights view:
http://www.monnit.com/support/hardware/gateways/ethernet/troubleshooting-a-monnit-
link-ethernet-gateway
2. Ethernet Gateway Controls
RP SMA Antenna ConnectorEthernet PortPower Plug
Control Button
Back Panel
Using the Control Button:
1) A short press will trigger the gateway to immediately send all stored sensor mes-
sages to the online system and download any pending system messages to deliver to
the sensors. (The default heartbeat for the Ethernet gateway is 5 minutes.)
2) Press and hold to reset the gateway to factory settings. Factory settings will be
reset to defaults, including the heartbeat setting of 5 minutes on both the gateway
and in the online system. DHCP, server addressing and port are all restored to default
settings, for example. You will need to login to the online system after resetting the
gateway to recongure the gateway to your desired settings.
Note: If your gateway powers up with the lights scrolling from left to right, it has entered into boot
loader mode accidentally. Make sure the button is free from obstruction and reboot the gateway by
removing the power plug, waiting for 10 seconds then reinserting the power plug.