User`s guide
Then actuate this coil to verify that the ID and CODES were
input correctly and to add the wireless device. If successful,
the coil write will also be successful. If the codes are incor-
rect, the coil write will return a “Modbus IO error message”.
REG_DEVICE_NOW 7 Writing True (1) to this coil will cause
the register values located in WDREG_
ID_H/L and WDREG_CODE1/2/3/4/5/6
to be evaluated. If the values are cor-
rect, the device specied will be added
to the Wireless Device List at the next
available slot. Always read as False (0).
When registering the rst wireless device, the second LED will
go red signifying there is no wired communication available,
then the third LED will start ashing while the wireless network
resets. Please wait approximately 30 seconds (until all LEDs
turn green, signifying a successful network reset) after regis-
tering the rst device, before attempting any other tasks.
You can verify that the network is active by polling the WAC-
TIVE coil at address 1. If it now returns true, the registration of
the rst wireless device is successful, and the wireless net-
work is now active.
Add more wireless devices using the same method, but you
will not need to wait 30 seconds after each. To see the current
wireless device count, read register 40004.
PAGE 7