User`s guide

- 31 -
CFG_INT_TYPE_
CALVAL_1_H
32
CFG_INT_TYPE_CAL
VAL
_
1
_
L
33
CFG_INT_TYPE_
CALVAL
_
2
_
H
34
CFG_INT_TYPE_
CALVAL
_
2
_
L
35
CFG_INT_TYPE_
CALVAL
_
3
_
H
36
CFG_INT_TYPE_
CALVAL
_
3
_
L
37
CFG_INT_TYPE_
CALVAL
_
4
_
H
38
CFG_INT_TYPE_
CALVAL_4_L
39
Device-Type Specific Parameter:
INTERVAL–TYPE DEVICE
Calibration / Control Values.
CFG_TRG_TYPE_
DETECT_TYPE
40
CFG_TRG_TYPE_
DETECT
_
PERIOD
41
CFG_TRG_TYPE_
DETECT
_
COUNT
42
CFG_TRG_TYPE_
DETECT
_
REARM
43
CFG_TRG_TYPE_
DETECT_BISTABLE
44
Device-Type Specific Parameter:
TRIGGER–TYPE DEVICE
Mode / Control Values.
UNUSED 45-49
Notes:
1. See Monnit’s Serial MODBUS Sensor Application Definition
document for more information on field definitions, enumeration,
and usage for these specific registers.
2. An Interval that specifies under 10 minutes must consider the
battery power usage and wireless network load the gateway may
experience if the CFG_INTERVAL parameters a set too low. It is
recommended to keep then network load to at most 10 device
reports per minute. The maximum interval for communications is
18 hrs → 64800 seconds.