Specifications

ACCESSORIES YOU MAY NEED
Check the list below and see your MPI dealer for accessories you may need or want for installation of your heating
system.
ACCESSORY
APPLICATION
Medium Flue Pipe P/N 8206
For use where wall thickness is up to \4
1
A inches
Long Flue Pipe P/N 8005
For use where wall thickness is up to 20 inches
Electric Lifter Pump P/N 1101
For use with large capacity tank where gravity feed is not
practical
Window Installation Kit P/N 8208, 8209, 8001
(See Window Installation below)
For use where "through-the window" flue pipe installation
is desired
Extra Short, Short, Medium or
Long Extension Kit or Elbow Adapter Kit
(See Flue Pipe Extensions, page 8)
For use where "standard" installation is not practical
Fitting and Tank
For large capacity fueling: To be dealer installed
WINDOW INSTALLATION
The use of "through-the-window" installation for your
flue pipe will require a window installation kit and one
of the 4 (extra short, short, medium or long) extension
kits.
In order to determine which extension kit is required,
measure the distance from the floor to the TOP of
your window sill (see Figure 2) and refer to the chart
below.
IF THE MEASUREMENT IS:
Fig. 2
YOU NEED
20% to 25 inches
Extra Short Extension Kit P/N 8212
25 to 33% inches
Short Extension Kit
P/N 8204
33% to 51
1
A inches
Medium Extension Kit
P/N 8203
51
1
A to86M inches Long Extension Kit
P/N 8202
Elbow Adapter Kit
P/N 8213
NOTE: Window kit installation is prohibited when the window is required to meet the local building code requirements
for ventilation, emergency escape, or rescue.
One or more Elbow Adapter Kit may be needed if heater is installed on inside wall.