Specifications

SECTION F
STARTING INSTRUCTIONS
Step 1: Plug in the Heater
Plug in the AC cord, and route it away from the area
of the flue pipe. It is recommended that no other
appliance share the same outlet.
Step 2: Prime the Heater
If using the heater for the first time, or if the heater
has not been in operation for sometime, press the fuel
set lever at the lower right hand side of the cabinet
and release it slowly 2 or 3 times (Figure 31).
/!\ CAUTION: Do not continue pressing lever repeat-
edly as this may cause overfilling of constant
level valve inside.
NOTE:After a power outage, there is a three-minute
waiting period before the unit restarts, provided
the ON/OFF switch is in the "ON" position.
Step 3: Set "ON" Button
Depress the operation button to put it in the "ON"
position. The "Operation Lamp" lights indicating "Set
Room Temperature" and "present room temperature".
Burner status lamps will light and ignition will start
after approximately three minutes. In 5 to 10 minutes
the circulation fan will start to operate, and warm air
will be felt coming through the cabinet grill.
Fuel Set Lever
Fig. 31
WEEKLY TIMER CONTROL
Mon Tue Wed Thu
S
Sat Sun
O O
DAY SET CLOCK SET TIMER SET
O
TEMP
AM
PM
SET ROOM
CD BURN
CD EMPTY
TIMER SELECTOR
Hold down for 3 sec.
Fig. 32
20