Specifications

TURNING OFF THE HEATER
RELIGHTING THE HEATER
To turn off the heater, press the Operation Button to put
it in the "Off" position (Figure 21). The operation light
will go out, and the fuel flow will stop.
After turning heater off the fans will continue to run until
unit has cooled down to the point where the fans will
automatically stop.
Automatic controls prevent your heater from relighting
after the Operation Button has been set to "Off" until
heater has cooled.
If the Operation Button is put in the "On" position
during the cooling period, the heater will automatically
relight at the end of the period.
PROGRAMMING THE HEATER
SETTING THE DAY OF WEEK ANDTHETIME
Step 1 :Set the Day of Week
Press the "SELECT" Button, at which time the "DAY SET"
Light will illuminate. The "Mon" Light will illuminate and
flash at this point.
Illuminate and flash the Light of the current day of the
week (e.g.; "Wed") by pressing the "UP" or "DOWN"
Button, and then press the "SET" Button to lock into
memory. The current day (e.g.; "Wed") light will illuminate
continuously.
Step 2:Set theTime
Press the "SELECT" Button, at which time the "CLOCK
SET" Light will illuminate. The LED indicator in the Display
Window will show 88:88 at this point.
Step 3:Set the Hour
Press the "HOUR" Button until the correct hour (either
A.M. or P.M.) appears in the window.
NOTE:The "HOUR" and "MINUTE" Buttons can be
pressed and held or pressed momentarily to
change the time.
Step 4:Set the Minute
Press the "MINUTE" Button until the correct time appears
in the window.
Immediately press the "SET" Button.
NOTE:lf the "SET" Button is not pressed within Iminute
after the time set, the programming will be
cancelled.
Mon Tue Wed Thu
O O CD CD
Fri Sat Sun
O O O
DAY SET CLOCK SET TIMER SET TIMER SELECTOR
TEMP
AM
PM
SET
ROOM
CD BURN
SELECT
Hold down lor 3 sec.
/0\ /Ox
ICONOMT CHILD
\PLUS7 \LOCK
OPERATION
O
ON/OFF
Fig. 22
19