Specifications

FLUE PIPE EXTENSIONS
Four standard extension kits are available from your
Monitor dealer. Most installations can be made with
one of these kits. In special cases, custom installations
may be required. These may be made with components
purchased from your dealer.
In any installation the following limitations MUST NOT
BE EXCEEDED:
1. Trie total length of the intake or exhaust pipe should
not exceed 10 feet (3.05m) with 3 elbows, 13 feet
(3.96m) with 2 elbows, or 16'/
2
feet (5.3m) with 1 elbow.
2. These elbows should include the one used at the
heater but not the one on the air supply hose nor the
integral bends in the flue pipe. (See Figure 2)
3. The correct damper as shown on Page 14 must be
used.
4. Follow carefully the instruction included with each
kit.
Exhaust Elbow
90° Joint
Air Supply Hose
Flue Pipe
Do not count
Fig. 2