Specifications

TURNING OFF THE HEATER RELIGHTING THE HEATER
To turn off the heater, press the Operation Button to put
it in the "Off" position (Figure 17). The operation light
will go out, and the fuel flow will stop.
After turning heater off the fans will continue to run until
unit has cooled down to the point where the fans will
automatically stop.
Automatic controls prevent your heater from relighting
after the Operation Button has been set to "Off" until
heater has cooled.
If the Operation Button is put in the "On" position
during the cooling period, the heater will automatically
relight at the end of the period.
PROGRAMMING THE HEATER
SETTING THE CLOCK
Step 1: Set the Timer Selector
Press the "Timer Selector" button, at which time the "Clock Set" Light will illuminate. The LED indicator in the
Display Window will show 88:88 at this point.
DISPLAY WINDOW
RUN AUTO
EC
?n?
Q
MY
BURNER STATUS
r l_Uo _
OPERATION TIMER SELECTOR
CLOCK
ON/OFF AUTO ECONOMY
SET 1st 2nd 3r
d 4th
SET J ROOM
TEMP
AM
PM
• n n
TIME/TEMP SET
EH
HOUR MINUTE SET CLEAR
CH EH EH EH
TEMP| | UP DOWN
TIMER SELECTOR
Fig. 18
Step 2: Set the Hour
Press the "Hour" Button until the correct hour (either
A.M. or P.M.) appears in the window.
Step 3: Set the Minute
Press the "Minute" Button until the correct time appears
in the window.
Immediately press the "Set" Button.
NOTE: If the "Set" Button is not pressed within 1 minute
after the time is set, the programming will be
cancelled.
NOTE: The "Hour" and "Minute" Buttons can be pressed
and held or pressed momentarily to change the
time.
18