Technical data

FastIron Ethernet Switch Administration Guide 43
53-1002637-02
Basic port parameter configuration
2
The ethernet stack-unit/slot/port parameter specifies the Ethernet port for which you want to
display the interface information.
The loopback option specifies the loopback port for which you want to display the interface
information.
The management option specifies the management port for which you want to display the interface
information.
The slot option specifies all the ports in a slot for which you want to display the interface
information.
The tunnel option specifies the tunnel port for which you want to display the interface information.
The ve option specifies the virtual routing (VE) port for which you want to display the interface
information.
Table 9 describes the output parameters of the show interface brief wide command.
TABLE 9 Output parameters of the show interface brief wide command
To display the complete port name for an Ethernet interface, enter a command such as the
following.
Brocade# show interface brief wide ethernet 1/1/23
PPort Link State Dupl Speed Trunk Tag Pvid Pri MAC Name
1/1/23 Up Forward Full 1G None No 1 0 748e.f82d.7a16 connected-
to-FCX
Syntax: show interface brief wide ethernet stack-unit/slot/port
For more information about field descriptions of the command output, refer Table 9.
Port speed and duplex mode modification
The Gigabit Ethernet copper ports are designed to auto-sense and auto-negotiate the speed and
duplex mode of the connected device. If the attached device does not support this operation, you
can manually enter the port speed to operate at either 10, 100, or 1000 Mbps. The default and
recommended setting is 10/100/1000 auto-sense.
Field Description
Port Specifies the port number.
Link Specifies the link state.
Port-State Specifies the current port state.
Speed Specifies the link speed.
Tag Specifies if the port is tagged or not.
Pvid Specifies the port VLAN ID.
Pri Specifies the priority.
MAC Specifies the MAC address.
Name Specifies the port name.