Technical data

FastIron Ethernet Switch Administration Guide 373
53-1002637-02
Syslog messages
A
Warning No global IP! cannot send IGMP msg. The device is configured for ip multicast
active but there is no configured IP address
and the device cannot send out IGMP
queries.
Warning No of prefixes received from BGP peer
ip-addr exceeds warning limit num
The Layer 3 switch has received more than
the allowed percentage of prefixes from the
neighbor.
The ip-addr is the IP address of the
neighbor.
The num is the number of prefixes that
matches the percentage you specified. For
example, if you specified a threshold of 100
prefixes and 75 percent as the warning
threshold, this message is generated if the
Layer 3 switch receives a 76th prefix from
the neighbor.
Warning rip filter list list-num direction V1 | V2 denied
ip-addr, num packets
Indicates that a RIP route filter denied
(dropped) packets.
The list-num is the ID of the filter list.
The direction indicates whether the filter
was applied to incoming packets or
outgoing packets. The value can be one of
the following:
• in
• out
The V1 or V2 value specifies the RIP version
(RIPv1 or RIPv2).
The ip-addr indicates the network number
in the denied updates.
The num indicates how many packets
matching the values above were dropped
during the five-minute interval represented
by the log entry.
Warning Temperature is over warning level. The chassis temperature has risen above
the warning level.
TABLE 1 Brocade Syslog messages (Continued)
Message level Message Explanation