Technical data

372 FastIron Ethernet Switch Administration Guide
53-1002637-02
Syslog messages
A
Warning list ACL-num denied ip-proto
src-ip-addr (src-tcp/udp-port)
(Ethernet portnum mac-addr) -
dst-ip-addr (dst-tcp/udp-port),
1 event(s)
Indicates that an Access Control List (ACL)
denied (dropped) packets.
The ACL-num indicates the ACL number.
Numbers 1 – 99 indicate standard ACLs.
Numbers 100 – 199 indicate extended
ACLs.
The ip-proto indicates the IP protocol of the
denied packets.
The src-ip-addr is the source IP address of
the denied packets.
The src-tcp/udp-port is the source TCP or
UDP port, if applicable, of the denied
packets.
The portnum indicates the port number on
which the packet was denied.
The mac-addr indicates the source MAC
address of the denied packets.
The dst-ip-addr indicates the destination IP
address of the denied packets.
The dst-tcp/udp-port indicates the
destination TCP or UDP port number, if
applicable, of the denied packets.
Warning Locked address violation at interface
eportnum, address mac-address
Indicates that a port on which you have
configured a lock-address filter received a
packet that was dropped because the
packet source MAC address did not match
an address learned by the port before the
lock took effect.
The eportnum is the port number.
The mac-address is the MAC address that
was denied by the address lock.
Assuming that you configured the port to
learn only the addresses that have valid
access to the port, this message indicates a
security violation.
Warning MAC filter group denied packets on port
portnum, src macaddr mac-addr, num
packets
Indicates that a MAC address filtergroup
configured on a port has denied packets.
The portnum is the port on which the
packets were denied.
The mac-addr is the source MAC address of
the denied packets.
The num indicates how many packets
matching the values above were dropped
during the five-minute interval represented
by the log entry.
Warning multicast no software resource:
resource-name, rate-limited
number
IGMP or MLD snooping has run out of
software resources. This message is
rate-limited to appear a maximum of once
every 10 minutes. The rate-limited number
shows the number of non-printed warnings.
TABLE 1 Brocade Syslog messages (Continued)
Message level Message Explanation