Technical data

FastIron Ethernet Switch Administration Guide 371
53-1002637-02
Syslog messages
A
Notification VRRP intf state changed, intf portnum, vrid
virtual-router-id, state vrrp-state
VRRP (IPv6) intf state changed, intf portnum,
vrid virtual-router-id, state vrrp-state
A state change has occurred in a Virtual
Router Redundancy Protocol (VRRP) or
VRRP-E IPv4 or IPv6 interface.
The portnum is the port or interface where
VRRP or VRRP-E is configured.
The virtual-router-id is the virtual router ID
(VRID) configured on the interface.
The vrrp-state can be one of the following:
• init
• master
• backup
• unknown
Warning DOT1X security violation at port portnum,
malicious MAC address detected:
mac-address
A security violation was encountered at the
specified port number.
Warning Dup IP ip-addr detected, sent from MAC
mac-addr interface portnum
Indicates that the Brocade device received
a packet from another device on the
network with an IP address that is also
configured on the Brocade device.
The ip-addr is the duplicate IP address.
The mac-addr is the MAC address of the
device with the duplicate IP address.
The portnum is the Brocade port that
received the packet with the duplicate IP
address. The address is the packet source
IP address.
Warning IGMP/MLD no hardware vidx, broadcast to
the entire vlan. rated limited number
IGMP or MLD snooping has run out of
hardware application VLANs. There are
4096 application VLANs per device. Traffic
streams for snooping entries without an
application VLAN are switched to the entire
VLAN and to the CPU to be dropped. This
message is rate-limited to appear a
maximum of once every 10 minutes. The
rate-limited number shows the number on
non-printed warnings.
Warning IGMP/MLD: vlanId(portId) is V1 but rcvd V2
from nbr ipAddr
Port has received a query with a MLD
version that does not match the port MLD
version. This message is rated-limited to
appear a maximum of once every 10 hours.
Warning Latched low RX Power | TX Power | TX Bias
Current | Supply Voltage | Temperature
warning alarm | warning, port port-number
The optical transceiver on the given port
has risen above or fallen below the alarm or
warning threshold.
TABLE 1 Brocade Syslog messages (Continued)
Message level Message Explanation