Technical data

FastIron Ethernet Switch Administration Guide 359
53-1002637-02
Syslog messages
A
Informational vlan vlan-id Bridge is RootBridge
mac-address (MgmtPriChg)
802.1W changed the current bridge to be
the root bridge of the given topology due to
administrative change in bridge priority.
Informational vlan vlan-id Bridge is RootBridge
mac-address (MsgAgeExpiry)
The message age expired on the Root port
so 802.1W changed the current bridge to
be the root bridge of the topology.
Informational vlan vlan-id interface portnum Bridge TC
Event (DOT1wTransition)
802.1W recognized a topology change
event in the bridge. The topology change
event is the forwarding action that started
on a non-edge Designated port or Root port.
Informational vlan vlan-id interface portnum STP state -
state (DOT1wTransition)
802.1W changed the state of a port to a
new state: forwarding, learning, blocking. If
the port changes to blocking, the bridge
port is in discarding state.
Informational vlan vlan-id New RootBridge mac-address
RootPort portnum (BpduRcvd)
802.1W selected a new root bridge as a
result of the BPDUs received on a bridge
port.
Informational vlan vlan-id New RootPort portnum
(RootSelection)
802.1W changed the port role to Root port,
using the root selection computation.
Notification ACL exceed max DMA L4 cam resource,
using flow based ACL instead
The port does not have enough Layer 4 CAM
entries for the ACL.
To correct this condition, allocate more
Layer 4 CAM entries. To allocate more Layer
4 CAM entries, enter the following
command at the CLI configuration level for
the interface:
ip access-group max-l4-cam num
Notification ACL insufficient L4 cam resource, using flow
based ACL instead
The port does not have a large enough CAM
partition for the ACLs
Notification ACL insufficient L4 session resource, using
flow based ACL instead
The device does not have enough Layer 4
session entries.
To correct this condition, allocate more
memory for sessions. To allocate more
memory, enter the following command at
the global CONFIG level of the CLI interface:
system-max session-limit num
Notification ACL port fragment packet inspect rate rate
exceeded on port portnum
The fragment rate allowed on an individual
interface has been exceeded.
The rate indicates the maximum rate
allowed.
The portnum indicates the port.
This message can occur if fragment
thottling is enabled.
Notification ACL system fragment packet inspect rate
rate exceeded
The fragment rate allowed on the device
has been exceeded.
The rate indicates the maximum rate
allowed.
This message can occur if fragment
thottling is enabled.
TABLE 1 Brocade Syslog messages (Continued)
Message level Message Explanation