Technical data

356 FastIron Ethernet Switch Administration Guide
53-1002637-02
Syslog messages
A
Informational Port portnum, srcip-security
max-ipaddr-per-int reached.Last IP=ipaddr
The address limit specified by the
srcip-security max-ipaddr-per-interface
command has been reached for the port.
Informational Port portnum, srcip-security
max-ipaddr-per-int reached.Last IP=ipaddr
The address limit specified by the
srcip-security max-ipaddr-per-interface
command has been reached for the port.
Informational Security: console login by username to USER
| PRIVILEGE EXEC mode
The specified user logged into the device
console into the specified EXEC mode.
Informational Security: console logout by username The specified user logged out of the device
console.
Informational Security: telnet | SSH login by username
from src IP ip-address, src MAC mac-address
to USER | PRIVILEGE EXEC mode
The specified user logged into the device
using Telnet or SSH from either or both the
specified IP address and MAC address. The
user logged into the specified EXEC mode.
Informational Security: telnet | SSH logout by username
from src IP ip-address, src MAC mac-address
to USER | PRIVILEGE EXEC mode
The specified user logged out of the device.
The user was using Telnet or SSH to access
the device from either or both the specified
IP address and MAC address. The user
logged out of the specified EXEC mode.
Informational SNMP read-only community | read-write
community | contact | location | user |
group | view | engineld | trap [host] [value
-str] deleted | added | modified from
console | telnet | ssh| snmp session
A user made SNMP configuration changes
through the SNMP, console, SSH, or Telnet
session.
[value-str] does not appear in the message
if SNMP community or engineld is specified.
Informational SNMP Auth. failure, intruder IP: ip-addr A user has tried to open a management
session with the device using an invalid
SNMP community string.
The ip-addr is the IP address of the host
that sent the invalid community string.
Informational SSH | telnet server enabled | disabled from
console | telnet | ssh| snmp session [by
user username]
A user enabled or disabled an SSH or Telnet
session, or changed the SSH
enable/disable configuration through the
SNMP, console, SSH, or Telnet session.
Informational startup-config was changed
or
startup-config was changed by user-name
A configuration change was saved to the
startup-config file.
The user-name is the user ID, if they
entered a user ID to log in.
Informational STP: Root Guard Port port-number, VLAN
vlan-ID consistent (Timeout).
Root guard unblocks a port.
Informational STP: Root Guard Port port-number, VLAN
vlan-ID inconsistent (Received superior
BPDU).
Root guard blocked a port.
Informational STP: VLAN vlan id BPDU-Guard on Port port
id triggered (Received BPDU), putting into
err-disable state
The BPDU guard feature has detected an
incoming BPDU on {vlan-id, port-id}
Informational STP: VLAN vlan id Root-Protect Port port id,
Consistent (Timeout)
The root protect feature goes back to the
consistent state.
TABLE 1 Brocade Syslog messages (Continued)
Message level Message Explanation