Technical data

354 FastIron Ethernet Switch Administration Guide
53-1002637-02
Syslog messages
A
Informational DOT1X: port portnum - MAC mac address
cannot remove inbound ACL
An error occurred while removing the
inbound ACL.
Informational DOT1X: port portnum - MAC mac address
Downloading a MAC filter, but MAC filter have
no effect on router port
The RADIUS server returned an MAC
address filter, but the portnum is a router
port (it has one or more IP addresses).
Informational DOT1X: port portnum - MAC mac address
Downloading an IP ACL, but IP ACL have no
effect on a switch port
The RADIUS server returned an IP ACL, but
the portnum is a switch port (no IP
address).
Informational DOT1X:port portnum - MAC mac address
Error - could not add all MAC filters
The Brocade device was unable to
implement the MAC address filters returned
by the RADIUS server.
Informational DOT1X: port portnum - MAC mac address
Invalid MAC filter ID - this ID doesn't exist
The MAC address filter ID returned by the
RADIUS server does not exist in the Brocade
configuration.
Informational DOT1X: port portnum - MAC mac address
Invalid MAC filter ID - this ID is user defined
and cannot be used
The port was assigned a MAC address filter
ID that had been dynamically created by
another user.
Informational DOT1X: port portnum - MAC mac address is
unauthorized because system resource is
not enough or the invalid information to set
the dynamic assigned IP ACLs or MAC
address filters
802.1X authentication failed for the Client
with the specified mac address on the
specified portnum either due to insufficient
system resources on the device, or due to
invalid IP ACL or MAC address filter
information returned by the RADIUS server.
Informational DOT1X: port portnum - MAC mac address
Port is already bound with MAC filter
The RADIUS server returned a MAC address
filter, but a MAC address filter had already
been applied to the port.
Informational DOT1X:port portnum - MAC mac address
This device doesn't support ACL with MAC
Filtering on the same port
The RADIUS server returned a MAC address
filter while an IP ACL was applied to the
port, or returned an IP ACL while a MAC
address filter was applied to the port.
Informational DOT1X: Port portnum is unauthorized
because system resource is not enough or
the invalid information to set the dynamic
assigned IP ACLs or MAC address filters
802.1X authentication could not take place
on the port. This happened because strict
security mode was enabled and one of the
following occurred:
• Insufficient system resources were
available on the device to apply an IP
ACL or MAC address filter to the port
• Invalid information was received from
the RADIUS server (for example, the
Filter-ID attribute did not refer to an
existing IP ACL or MAC address filter)
Informational DOT1X: Port portnum currently used vlan-id
changes to vlan-id due to dot1x-RADIUS vlan
assignment
A user has completed 802.1X
authentication. The profile received from
the RADIUS server specifies a VLAN ID for
the user. The port to which the user is
connected has been moved to the VLAN
indicated by vlan-id.
Informational DOT1X: Port portnum currently used vlan-id
is set back to port default vlan-id vlan-id
The user connected to portnum has
disconnected, causing the port to be moved
back into its default VLAN, vlan-id.
TABLE 1 Brocade Syslog messages (Continued)
Message level Message Explanation