Technical data

336 FastIron Ethernet Switch Administration Guide
53-1002637-02
sysmon xbar link
sysmon xbar link
Configures the sysmon parameters for the crossbar link. The no form of this command resets the
parameters to default values.
Syntax sysmon xbar link {threshold events polling-interval |log-backoff value | action {none | syslog}}
no sysmon xbar link
Command
Default
By default, the command takes the global values defined for threshold, log back-off, and action.
Parameters threshold Defines the failure threshold for the fabric adapter error-count event. The
threshold is defined as N/W, where N is the number of events, and W is the
number of consecutive polling periods. When the threshold is reached,
actions configured for this event type will take place. Note that a threshold of
1/W implies that there is no threshold, and no event will be triggered.
events Specifies the threshold in terms of the number of events. Valid values are 1
through 10.
polling-interval Specifies the number of polling windows. The device polls the internal
registers at the interval specified by the sysmon timer value. Valid values
1-32. However, the polling window number must be equal or greater than the
number of events.
log-backoff If an error condition persists, it will be continuously logged (internally and/or
externally). The log back-off count skips configured number of logs before
logging again. This avoids overflow of the internal log or of the syslog.
action Specifies the action to take when the error count exceeds the specified
threshold and log back-off values.
none No action is taken.
syslog The error is logged to syslog.
Command
Modes
Global configuration mode.
Usage
Guidelines
This command is supported only on FSX devices.
Examples The following example configures system monitoring for cross bar link errors:
Brocade(config)# sysmon xbar link threshold 3 7
Brocade(config)# sysmon xbar link action syslog
Brocade(config)# sysmon xbar link log-backoff 15
History
Related
Commands
sysmon xbar error-count, sysmon timer, sysmon threshold
Release Command History
08.0.00a This command was introduced.