Technical data

324 FastIron Ethernet Switch Administration Guide
53-1002637-02
sysmon threshold
sysmon threshold
Defines the threshold for errors at the global level. The no form of this command resets the
threshold configuration to default values.
Syntax sysmon threshold events polling-interval
no sysmon threshold
Parameters events Specifies the threshold in terms of the number of events. Valid values are 1
through 10. When expressed in the command, the default value is 2.
polling-interval Specifies the number of polling windows. The device polls the internal
registers at the interval specified by the sysmon timer value. Valid values
1-32. However, the polling window number must be equal or greater than the
number of events. When expressed in the command, the default value is 10.
Command
Modes
Global configuration mode.
Usage
Guidelines
The type-specific threshold values that you define overrides the global threshold value for each
event. However, if you define the global value later, the latest value prevails. The threshold is
defined as N/W, where N is the number of events, and W is the number of consecutive polling
periods. When the threshold is reached, actions configured for this event type will take place. Note
that a threshold of 1/W implies that there is no threshold, and the action will always be triggered.
Examples The following example sets the threshold to 3 events over 7 consecutive polling periods:
Brocade(config)# sysmon threshold 3 7
History
Related
Commands
sysmon fa error-count, sysmon fa link, sysmon pp error-count, sysmon xbar error-count, sysmon
xbar link,
Release Command History
08.0.00a This command was introduced.