Technical data

FastIron Ethernet Switch Administration Guide 13
53-1002637-02
Chapter
2
Basic Software Features
Table 5 lists the individual Brocade FastIron switches and the basic software features they support.
These features are supported in the Layer 2 and Layer 3 software images, except where explicitly
noted.
TABLE 5 Supported basic software features
Feature FSX 800
FSX 1600
FCX ICX 6610 ICX 6430 ICX 6450
Basic System Parameters
System name, contact, and location Yes Yes Yes Yes Yes
SNMP trap receiver and trap source
address
Yes Yes Yes Yes Yes
Virtual routing interface statistics via
SNMP
YesNoNoNoNo
Disable Syslog messages and traps for CLI
access
Yes Yes Yes Yes Yes
Cancelling an outbound Telnet session Yes Yes Yes Yes Yes
Network Time Protocol Version 4 (NTPv4) Yes
1
Yes (on the
router code
only)
Yes Yes Yes
System clock Yes Yes Yes Yes Yes
Byte-based broadcast, multicast, and
unknown-unicast limits
YesNoNoNoNo
Packet-based broadcast, multicast, and
unknown-unicast limits
Yes Yes Yes Yes Yes
CLI banners Yes Yes Yes Yes Yes
Local MAC address for Layer 2
management traffic
No Yes Yes Yes Yes
Show Interface Enhancements Yes Yes Yes Yes Yes
Basic Port Parameters
Port name Yes Yes Yes Yes Yes
Enhancement to Port Group Naming Yes Yes Yes Yes Yes
10/100/1000 port speed Yes Yes Yes Yes Yes
Auto-negotiation Yes Yes Yes Yes Yes
Auto-negotiation maximum port speed
advertisement and down-shift
Yes Yes Yes Yes Yes
Duplex mode Yes Yes Yes Yes Yes
Auto MDI/MDIX detection Yes Yes Yes Yes Yes