Technical data

FastIron Ethernet Switch Administration Guide 151
53-1002637-02
Chapter
5
IPv6
Table 1 lists the individual Brocade FastIron switches and the IPv6 features they support. These
features are supported with premium IPv6 devices running the full Layer 3 software image.
This chapter contains the following sections:
Static IPv6 route configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 151
IPv6 over IPv4 tunnels. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 154
ECMP load sharing for IPv6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 159
Static IPv6 route configuration
NOTE
Static IPv6 route configuration is supported only with the IPv6 Layer 3 license on FSX devices and
the full Layer 3 image on other devices.
You can configure a static IPv6 route to be redistributed into a routing protocol, but you cannot
redistribute routes learned by a routing protocol into the static IPv6 routing table.
NOTE
The maximum IPv6 static routes supported on an ICX 6450 device is 1070.
Before configuring a static IPv6 route, you must enable the forwarding of IPv6 traffic on the Layer 3
switch using the ipv6 unicast-routing command and enable IPv6 on at least one interface by
configuring an IPv6 address or explicitly enabling IPv6 on that interface. For more information on
performing these configuration tasks, refer to “Configuring IPv4 and IPv6 protocol stacks” section
in the FastIron Ethernet Switch Administration Guide.
Configuring a static IPv6 route
To configure a static IPv6 route for a destination network with the prefix 2001:DB8::0/32, a
next-hop gateway with the global address 2001:DB8:0:ee44::1, and an administrative distance of
110, enter the following command.
Brocade(config)#ipv6 route 2001:DB8::0/32 2001:DB8:2343:0:ee44::1 distance 110
TABLE 1 Supported IPv6 features
Feature FSX 800
FSX 1600
FCX ICX 6610 ICX 6450 ICX 6430
Static IPv6 Routing Yes
a
a. Third generation modules.
YesYesYesNo
IPv6 over IPv4 tunnels Yes Yes Yes No No
ECMP load sharing Yes Yes Yes Yes No