Technical data

FastIron Ethernet Switch Administration Guide 95
53-1002637-02
Diagnostic error codes and remedies for TFTP transfers
3
This section describes the error messages associated with the TFTP transfer of PoE firmware file to
a Brocade device.
6 TFTP out of buffer space. The file is larger than the amount of room on the device or TFTP server.
If you are copying an image file to flash, first copy the other image to
your TFTP server, then delete it from flash. (Use the erase flash... CLI
command at the Privileged EXEC level to erase the image in the flash.)
If you are copying a configuration file to flash, edit the file to remove
unnecessary information, then try again.
7 TFTP busy, only one TFTP
session can be active.
Another TFTP transfer is active on another CLI session or network
management system.
Wait, then retry the transfer.
8 File type check failed. You accidentally attempted to copy the incorrect image code into the
system. For example, you might have tried to copy a Chassis image into
a Compact device.
Retry the transfer using the correct image.
16 TFTP remote - general error. The TFTP configuration has an error. The specific error message
describes the error.
Correct the error, then retry the transfer.
17 TFTP remote - no such file.
18 TFTP remote - access violation.
19 TFTP remote - disk full.
20 TFTP remote - illegal operation.
21 TFTP remote - unknown
transfer ID.
22 TFTP remote - file already
exists.
23 TFTP remote - no such user.
Message Explanation and action
Firmware TFTP timeout. TFTP failed because of a time out.
Check IP connectivity and make sure the TFTP server is running.
Firmware is not valid for this
platform.
Each PoE firmware file delivered by Brocade is meant to be used on the
specific platform only. If the file is used on a platform for which it is not
meant, then this error message will display.
Download the correct file, then retry the transfer.
Firmware is not valid for the
IEEE 802.3at (PoE-Plus)
controller type.
Each PoE firmware file delivered by Brocade is meant to be used on the
specific platform only. If the file is used on a platform for which it is not
meant, then this error message will display.
Download the correct file, then retry the transfer.
Firmware is not valid for the
IEEE 802.3af PoE controller
type.
Error
code
Message Explanation and action