User manual

18
19
English
English
Delay:
(10s/1m/3m/5m/
10m/15m/30m)
Select the time interval between photos or
videos.
Additional setting: it is possible to
decrease the delay between detections to 10
seconds (instead of 1 minute) by using the
following procedure. Note that the battery
life will be affected.
Turn OFF the camera. Press and hold the
"" button and turn the camera ON . "10sec
enabled" appears on the screen meaning
the minimum delay is now 10 seconds. If
this option is used, the 30 minute delay
disappears. To reset the camera to 1 minute
delay, follow the same procedure. "10sec
disabled" appears on the screen (see figure
below)
Multi-shot:
(1/2/3/4/5/6
consecutive
shots)
Take up to 6 consecutive shots at each
detection, with a 10 second delay between
each photo. This option allows up to 6
pictures from different angles when the
camera is in "Photo" mode.
Wireless:
(On/Off)
Enables or disables the wireless
transmission of images to the Blackbox-
D
TM
controller (supplied with the TINY-W3/
S-TINY-W3).
When the transmission is enabled:
• Only pictures are transmitted to the
controller, not videos.
• The quality of the photos on the controller
is reduced to maximize transmission:
10MP = 800 x 600 pixels
5MP = 640 x 480 pixels
3MP = 320 x 240 pixels
• When in
"Time Lapse" mode, photos
are sent to the controller except for the
"30s" setting.
• When the delay setting "10s" is selected,
the time between each detection is
calculated when the transmission is
completed. For example, if the transmission
takes two seconds, the time between the two
detections is 12 seconds.
Note: When the wireless option is activated,
it is only possible to take up to 2 consecutive
shots.
10SEC DISABLED10SEC ENABLED
10 sec delay 1 min delay