Specifications

For ﬁxing to a wooden wall/structure, use a 2mm drill bit to drill 2 pilot holes and use 3.

25mm screws to secure the bracket.

Fully unscrew the 2 wall bracket mounting screws in the back of the speaker cabinet 4.

using the ‘hex’ key provide (Fig. 4). Using the two screws that have just been removed,

attach the forked part of the wall bracket to the back of the speaker (Fig. 5). This

should be tightened securely.

Connect the speaker cables as in Fig. 6. 5.

Alternatively, you can use bare wire. Place

the female ball part of the bracket over the

male part, ensuring the slot in the female

part lines up with the hole in the male

part.

Using the 30mm cap head bolt (provided) 6.

secure the two parts together, but leave

the bolt loose enough to allow some

adjustment if necessary (Fig. 7).

Adjust the speaker to the desired listening 7.

position and fully tighten the bolt. If you realise this

is not the correct positioning, loosen the bolt slightly,

re-adjust and then tighten the bolt.

Connect your speaker cable to the ampliﬁer

Radius

Figure 4.

Figure 6.

Figure 5.

Figure 7.