Owner's Manual
Table Of Contents
Prior
to
Fitting
the
Controlled
Perfomance
Series
S
12
ea
kers
CAUTION: These Controlled Perfomance loudspeakers can only be fixed into plasterboard (dry-lined)
or
suspended
ceilings/ walls with a thickness
of
up to 45mm
(1
314
").
Solid wall installation will require channeling out and frame
work constructed
to
provide a structure for the
Tri
Grip®
dog legs to clamp to. For safety reasons, if you are unsure
of
your ability
to
provide a secure and safe fixing,
do
not attempt
to
fix these speakers, please obtain the services
of
a competent and qualified trades person.
CAUTION: Ensure that there are no water pipes or electricity cables running within the wall structure before cutting
the speaker apertures. Work from secure steps and avoid trailing wires.
Ov
er
Tightening
Warning
& ATTENTION INSTALLERS:
Do not over-tighten the Tri-Grip Dog Leg clamps. Over tightening the clamping mechanism on any
in
ceiling/
in
wall speaker
can result
in
damage
to
the speaker mounting hardware, ceiling/ wall or speaker frame,
and/
or deflection
in
the speaker
frame during installation.
If you notice any of the above during installation, you have overtightened the
Tri
Grip dog leg. Back off the mounting screw
until deflection
is
reduced to allow the product
to
sit firmly against the
ceiling/
wall.
&
Do
not exceed
5Kgf/cm
(4.34 lbf/inch.)
or
0.5
NM
when tightening the
Tri
Grip dog leg screws.
When are using a cordless screwdriver/ drill to install this product ensure the clutch
is
set
to
it's lowest setting
to
avoid from
over-tightening and damaging the mounting hardware.
©
✓
x®
;=3inting
the
Gr
il
l
es
.& NOTE:
If
choosing
to
paint the grille, we recommend you follow these simple steps:
Remove the membrane scrim from the inside of the grille.
2. Paint
all
grilles required for the installation with the same batch
of
paint
(if
they are to be the same colour). Spray paint
is
easier
to
apply or use a stippling action when brushing
to
avoid blocking the holes
of
the grille.
3. When
dry,
attach the spare membrane scrim (supplied) into the inside of the grille.
4. Fit the grille
to
the speaker
(s).