Instruction manual
Table Of Contents
- Introduction
- Your Bronze BR-FX
- Fixing Your Bronze BR-FX to a Wall
- Connecting your Bronze BR-FX
- Positioning
- Try varying the distance your loudspeakers are apart from each other. If they are too close together, this may result in poor stereo imaging. This is when sound moves from left to right or right to left, for example a car in a movie sound track. But if you place them too far apart, there will be a big gap in the imaging. When listening to music through your speakers, if you have them set up correctly, you shouldn’t notice that the speakers are even there, the music should sound as if it is coming from the centre of the two speakers.
- Running-In
- Port Bungs
- Bookshelf Loudspeakers
- Floor-Standing Loudspeakers
- Foam port bungs are supplied for all speakers with and ATR port tube. The port bungs are another way of fine-tuning the loudspeaker to fit in sonically in your home environment.
- Guarantee and Service
Your Bronze BR1
The BR1 remains the ‘baby’ of the Bronze Reference Series. Improved driver
and tweeter technologies help to propel the BR1 ahead of its predecessor.
Overall bandwidth has been increased with usable frequency response right out
to 30KHz. Improved motor system linearity has resulted in lower distortion and
low frequency damping. The BR1 is now single wired, but improved terminal
quality lifts the overall desirability of this entry level monitor.
Because the BR1 offers huge performance from a small speaker, it lends itself
to a wide range of positioning options. The BR1 will perform equally well no
matter how it is positioned. The BR1 can be placed on a stand, on a book-shelf,
it can even be hung on a wall using a wall bracket (not supplied). The BR1 has a
¼” UNC threaded insert in the back of the cabinet to allow it to be wall
mounted. Please note that when using a wall bracket we would recommend
using the enclosed port bungs to eliminate ‘bass boom’ and unwanted air
turbulence caused by the bracket.
Frequency
Response
Sensitivity
(1W@1m)
Nominal Impedance
(Ohms)
Power
Handling
RMS (W)
Recommended
Amplifier Power
Output.
55Hz – 30KHz 88dB 6 70 15 - 70W
Drive Unit
Complement
Cabinet
Design
Product External
Dimensions
cm (inch)
Weight
(packed)
Kg (lb)
Finishes
1 x 5.5" MMP
®
Mk2
Bass mid-range.
1 x 25mm Gold Dome
C-CAM
®
tweeter.
Rear ported,
bass reflex
26H x 16.5W x 18D
(10 ¼ x 6 ½ x 7
1
/
16
)
8.7 (19.1)
Black Oak,
Walnut, Cherry.
4
Rev4. © Monitor Audio 2006