Instruction manual
Table Of Contents
- Introduction
- Your Bronze BR-FX
- Fixing Your Bronze BR-FX to a Wall
- Connecting your Bronze BR-FX
- Positioning
- Try varying the distance your loudspeakers are apart from each other. If they are too close together, this may result in poor stereo imaging. This is when sound moves from left to right or right to left, for example a car in a movie sound track. But if you place them too far apart, there will be a big gap in the imaging. When listening to music through your speakers, if you have them set up correctly, you shouldn’t notice that the speakers are even there, the music should sound as if it is coming from the centre of the two speakers.
- Running-In
- Port Bungs
- Bookshelf Loudspeakers
- Floor-Standing Loudspeakers
- Foam port bungs are supplied for all speakers with and ATR port tube. The port bungs are another way of fine-tuning the loudspeaker to fit in sonically in your home environment.
- Guarantee and Service
Connecting Your Bronze Reference Loudspeakers
You will notice that when you unpack your loudspeaker, there are plastic
terminal caps in the terminals where the speaker cable connectors should go.
These can be simply removed by placing a thin, flat object underneath them and
carefully levering them free.
The BR2, BR5 & BR6 can be either single or bi-wired. At Monitor Audio, we
would always recommend bi-wiring your loudspeakers for improved sound
quality. If you are going to be connecting your speakers in a bi-wire format,
please remove the terminal links. This is done by unscrewing the red and black
terminals slightly and removing the link. Connect them as in the below, left.
You can also bi-amp your loudspeakers. The top terminals are for the HF, and
the bottom terminals are for the LF. In the cases where there is a mid bass unit
(BR5 and BR6), this is connected to the top terminals
The BR1, BR-LCR & BR-FX are single wire only. This can be seen in the
illustration below, centre.
However if neither of these options are open to you, please connect your
loudspeakers as in the illustration below, right. Please remember to leave the
terminal links in.
Single-Wire Format
BR1, LCR Wiring
Bi- Wire Format
13
Rev4. © Monitor Audio 2006