Owner's Manual

6 Bronze Series
Trouble Shooting
Should you experience any technical, or set-up problems with your subwoofer please check the Trouble
Shooting guide below:
My subwoofer will not turn on/ no power.
• Is the LED illuminated on the top of the unit? If not, check your mains lead is properly connected both
at the subwoofer and at the mains outlet. Also check the fuse of the amplifier and mains plug (where
fitted).
• Is the LED red? If so, you have power going to the unit. It could be that there is no signal, or the 12v
trigger is connected and the source not turned on (see below).
• Have you got the 12v trigger connected? If so, the subwoofer will not power up until the source is
turned on.
• Is the unit receiving a signal (12v trigger not being used)? Is the Power Mode Switch in Auto or On
position, and signal source turned on? Try adjusting the volume level of the source.
If it still does not turn on/ power up, please contact your local dealer/ distributor or Monitor Audio
immediately.
No sound from subwoofer.
• Is the LED on the top red or green? If it is red, then the unit hasn’t actually turned on. See above
suggestions. If it is green, then your unit is powered up and turned on. Check further suggestions
below.
• Are the signal leads connected correctly? Check these. If possible, check by replacing with a
second, working set.
• Is the volume level just very low? Try turning the volume on the source up a bit more.
• Have you tried switching input’s? If changing from LFE to Stereo (or vice versa), you need to power
down the sub woofer first. It will stay “locked” onto the input that activates it.
If it still does not output a signal, please contact your local dealer/ distributor or Monitor Audio immediately.